Camera Strap Cover

I have been wanting to make my camera strap a bit more snazzy and found a simple idea for one on Design Sponge.  You can check it out here.  

I measured the width of my camera strap and then added a 1/2 inch.

Then I measured the length and added an inch.

Cut out your strip and you're ready to press and sew.

As seen below, fold up the end 1/4 inch and then 1/4 inch again and press.  Then sew across.  Do the same to the opposite end of the strip.

 Next, fold the strip in half, right sides together and sew a 1/4 inch seam down the long side:  

 Press the seam open:

 Turn the tube right side out, and slip your camera strap right on in.  Done!